2.2kw ER20 VFD Air Cooled Spindle Motor

About 2.2kw ER20 VFD Air Cooled Spindle Motor

Basic parameters of 2.2kw ER20 air cooled spindle:

• Size:173x82x95mmWith Mounting Flange
• Speed Ways:Through 3-phase output inverter and adjust the inverter frequency to change the spindle speed.
• Cooling:Air cooling
• Power Interface:Optional 5 pins waterproof air plug. The air plug marked 1 ,2, 3, 4 5 GND. 1 ,2 ,3 were connected to inverter (U, V, W), GND connected inverter ground.
  (Pay attention! our spindle 4 connecting to GND,promised personal safety!!)
• Power:2.2kw(1HP=0.735kw)
• Voltage:220v
• Current:8.5A
• Frequency:0-300Hz/0-400Hz
• Speed:0-18000rpm/0-24000rpm(If you choose ceramic ball bearings, the speed can be 24000rpm)
• Runout Off:Less than 0.01mm
• Bearing type:27005 C P4 DT & 27002 C P4 DT
• Collet:ER20
• Clip Knifediameter:1mm,2mm,3mm,3.175mm(1/8),4mm,5mm,6mm,6.35mm(1/4),7mm, 8mm,9mm,10mm,11mm,12mm,12.7mm(1/2),13mm
• Grease Lubrication
• Main Application:Engrave for wood,bamboo,normal PCB,PVC,PMMA,plastic,duotone board(ABS)and etc nonmetal, also can engrave on gold,silver,copper, aluminium,Pb etc soft metal surface working.(Please pay more attention, this is wood working spindle, only can used for wood working and aluminum working,please dont use it for steel. If you need steel working,please check the metal spindle,thank you!)

Main Application of 2.2kw Air cooled Spindle:

Engrave for wood, bamboo, normal PCB, PVC, PMMA, plastic, duotone board(ABS)and etc non-metal, also can engrave on gold, silver, copper, aluminium, Pb etc soft metal surface working.